Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Buderus Fault code Buderus
0A

Waiting before the burner restarts

Information: nothing to do

The boiler is waiting before it lights its burner again: the delay between two starts, or the period that keeps the hot water hot, has not run out yet. This is an operating message, not a fault.

What you can do

  1. Check that enough radiators are open.
  2. Bleed the radiators, then check the water pressure again.

Nothing to do

This message belongs to the boiler's normal operation.

Call us
Buderus

Choose a real expert

Ecowatt is an approved Buderus System Partner: factory training in Germany, direct access to spare parts, one contact.

The variants of code 0A

The small number shown beside the code tells which.

0A
202

Cycle lock active: the burner restart cycle has not yet been reached (→ service…

Information: nothing to do GB072, GB162, GB172, GB172i
0A
305

Waiting phase of the gas condensing boiler after domestic hot water production has ended

Information: nothing to do GB072, GB162, GB172, GB172i
0A
353

Waiting phase of the gas condensing boiler

Information: nothing to do GB162

The boilers that show this code

What our technician checks

  • The output setting of the boiler and the controller, matched to the building's heat demand (floor-standing boilers, which also show this code)

The same fault on other boilers

Recent boilers show alone the number older ones show beside the code.

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.