Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Buderus Fault code Buderus
202

Pause between two burner starts

Information: nothing to do

A new heat demand comes in shortly after the burner has stopped: the boiler waits for the minimum delay to end before lighting it again (start optimization program). This is a normal operating message: there is nothing to do.

Nothing to do

This message belongs to the boiler's normal operation.

Call us
Buderus

Choose a real expert

Ecowatt is an approved Buderus System Partner: factory training in Germany, direct access to spare parts, one contact.

The variants of code 202

The small number shown beside the code tells which.

202

Appliance in the control optimisation programme

Information: nothing to do GB172i.2, GB182i.2, GB192i, GB192i.2, GB272

The boilers that show this code

The same fault on other boilers

Recent boilers show alone the number older ones show beside the code.

0A

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.