Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Buderus Fault code Buderus
2F

Water temperature not rising as expected

Breakdown: the boiler is stopped

After the burner starts, the water temperature does not rise, or the boiler's two sensors measure temperatures that are too far apart. Depending on the number shown next to it, the boiler stops temporarily or locks out.

What you can do

  1. Write down the code shown, the number next to it if there is one, and the boiler model (on the rating plate).
  2. Check that enough radiators are open.
  3. Bleed the radiators, then check the water pressure again.
  4. Reset the boiler once only.
  5. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show 2F?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

Buderus

Choose a real expert

Ecowatt is an approved Buderus System Partner: factory training in Germany, direct access to spare parts, one contact.

The variants of code 2F

The small number shown beside the code tells which.

2F
260

The flow temperature sensor does not measure any temperature rise after the burner has…

Blocking: it retries by itself GB162
2F
271

The difference between the temperature measured by the flow temperature sensor and that…

Blocking: it retries by itself GB162
2F
338

Start test interrupted too often

Breakdown: the boiler is stopped GB162
2F
345

The flow temperature sensor does not measure any temperature rise after the burner has…

Breakdown: the boiler is stopped GB162

The boilers that show this code

What our technician checks

  • The water pressure, and venting of the system and the boiler
  • The water flow rate in the system
  • The pump and the sensor concerned: wiring and operation; replaced if necessary

The same fault on other boilers

Recent boilers show alone the number older ones show beside the code.

260

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.