Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Buderus Fault code Buderus
260

No temperature rise after ignition

Breakdown: the boiler is stopped

After the burner starts, the flow temperature sensor does not see the water temperature rise. Depending on the model, the boiler stops temporarily or locks out.

What you can do

  1. Write down the code shown, the number next to it if there is one, and the boiler model (on the rating plate).
  2. Check that enough radiators are open.
  3. Bleed the radiators, then check the water pressure again.
  4. Reset the boiler once only.
  5. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show 260?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

Buderus

Choose a real expert

Ecowatt is an approved Buderus System Partner: factory training in Germany, direct access to spare parts, one contact.

The variants of code 260

The small number shown beside the code tells which.

260

The flow temperature sensor does not measure any temperature rise after the burner has…

Breakdown: the boiler is stopped GB192i

The boilers that show this code

What our technician checks

  • The water pressure, and venting of the boiler and the system
  • The water flow rate in the system
  • The pump and the flow temperature sensor: wiring and operation; replaced if needed

The same fault on other boilers

Recent boilers show alone the number older ones show beside the code.

2F

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.