Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Buderus Fault code Buderus
0Y

Heating water hotter than expected

Blocking: it retries by itself

The water temperature measured in the boiler is above the set point, or above 95 °C at the flow, return or safety sensor, or too high at the hot water sensor. This is not a lockout: the boiler restarts by itself as soon as the cause is gone.

What you can do

  1. Write down the code shown, the number next to it if there is one, and the boiler model (on the rating plate).
  2. Check the water pressure: at least 1 bar, or the needle in the green zone of the pressure gauge. Too low? Top up with the boiler cold, the way your installer showed you.
  3. Check that enough radiators are open.
  4. Bleed the radiators, then check the water pressure again.
  5. Reset the boiler once only.
  6. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show 0Y?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

Buderus

Choose a real expert

Ecowatt is an approved Buderus System Partner: factory training in Germany, direct access to spare parts, one contact.

The variants of code 0Y

The small number shown beside the code tells which.

0Y
204

The current flow temperature is higher than the set flow temperature

Information: nothing to do GB072, GB162, GB172, GB172i
0Y
276

The temperature at the flow temperature sensor is > 95 °C

Blocking: it retries by itself GB072, GB162, GB172, GB172i
0Y
277

The temperature measured by the safety temperature sensor is higher than 95 °C

Blocking: it retries by itself GB162
0Y
285

The temperature measured by the return temperature sensor is higher than 95 °C

Blocking: it retries by itself GB162
0Y
359

The temperature at the DHW temperature sensor is too high

Blocking: it retries by itself GB072, GB172, GB172i

The boilers that show this code

What our technician checks

  • The operating pressure and venting of the system and the boiler
  • The water flow rate in the system, with the isolation valves fully open
  • The heating pump: connection, start-up, pump output or pump curve setting, replaced if needed
  • The flow, return and safety sensors and their cables (open circuit, short circuit)
  • The hot water sensor: mounting position, cable, sensor replaced if needed
  • The KIM (GB072, GB172), properly inserted, replaced if needed
  • The set heating water temperature, the heating curve and the cylinder sensor (GB162)

The same fault on other boilers

Recent boilers show alone the number older ones show beside the code.

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.