Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Buderus Fault code Buderus
276

Heating water too hot (over 95 °C)

Information: nothing to do

The flow temperature sensor measures heating water above 95 °C. This message can appear without any fault, when all the radiator valves close at the same time.

What you can do

  1. Check the water pressure: at least 1 bar, or the needle in the green zone of the pressure gauge. Too low? Top up with the boiler cold, the way your installer showed you.
  2. Check that enough radiators are open.
  3. Bleed the radiators.
  4. Does the code stay on or come back? Do not take anything apart: call us.

Nothing to do

This message belongs to the boiler's normal operation.

Call us
Buderus

Choose a real expert

Ecowatt is an approved Buderus System Partner: factory training in Germany, direct access to spare parts, one contact.

The variants of code 276

The small number shown beside the code tells which.

276

The temperature at the flow temperature sensor is > 95 °C

Information: nothing to do GB192i

The boilers that show this code

What our technician checks

  • The system water pressure
  • The isolation valves, open
  • The pump: continuous running in the function test, connection cable, start-up; replaced if necessary
  • The setting of the pump output or pump curve
  • The flow temperature sensor and its cable (open circuit, short circuit)

The same fault on other boilers

Recent boilers show alone the number older ones show beside the code.

0Y

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.