Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Remeha Fault code Remeha
A02.33

Automatic filling takes too long

Blocking: it retries by itself

The automatic filling device has been adding water to the system for longer than the maximum time, and filling stops. It is a warning: the boiler keeps running normally, but the cause must be found, for example a leak or a main water tap that is not fully open.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Check that the main water tap is fully open.
  3. Look for a visible water leak on the boiler or the system.
  4. Does the code stay on or come back? Do not take anything apart: call us.

Does your boiler show A02.33?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code A02.33

The meaning depends on the boiler: find yours below.

A02.33

Maximum fill time exceeded error

Blocking: it retries by itself Calenta Ace-Matic, Tzerra Ace-Matic
A02.33

Auto-fill comm err

Blocking: it retries by itself Calenta Ace
A02.33

Communication timeout with the automatic top-up filling installation

Blocking: it retries by itself Tzerra Ace

What our technician checks

  • The main water tap and the filling tap
  • The boiler and the system, for leaks
  • The pressure switch wiring
  • The filling settings AP069 and AP070
  • The automatic filling unit, replaced if its valve is faulty
  • The circuit board, replaced if needed

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.