Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Mitsubishi Electric Fault code Mitsubishi Electric
LP

Water flow outside the outdoor unit range

Breakdown: the boiler is stopped

On an Ecodan heat pump (FTC6, FTC7, F generation), LP means the water flow is outside the range allowed for the heat pump's outdoor unit: the manual has the installation and the flow settings checked, then the same points as for L3 (leak, blocked strainer, circulation pump). It is a fault that does not clear by itself: our technician clears the code (reset) once the cause has been found.

What you can do

  1. Write down the code shown and the heat pump model (on the rating plate).
  2. Does the code stay on or come back? Do not take anything apart: call us.

Does your boiler show LP?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code LP

The meaning depends on the boiler: find yours below.

LP

Out of water flow rate range for outdoor heat pump unit

Breakdown: the boiler is stopped Ecodan F generation, Ecodan FTC6, Ecodan FTC7

What our technician checks

  • The system water flow rate against the range in table 4.3.1 (4-2 on the F generation)
  • The flow rate range settings in the remote controller service menu
  • Water leaks in the circuit
  • The strainer, and the magnetic filter on FTC7 and F generation
  • The water circulation pump

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.