Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
De Dietrich Fault code De Dietrich
L250

Water pressure too low

Breakdown: the boiler is stopped

The heating water pressure is too low: the system has not been bled properly, there is a water leak, or the reading is wrong (Innovens MCA, Modulens G AGC). It is a lockout fault: the control panel shows the code and the boiler stays off until it is reset.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Check the water pressure on the display: below 0.8 bar, top up with water as the user manual explains (recommended pressure 1.5 to 2.0 bar).
  3. Reset the boiler once only.
  4. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show L250?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code L250

The meaning depends on the boiler: find yours below.

L250

DEF.MANQUE EAU

Breakdown: the boiler is stopped Innovens MCA, Modulens G AGC

The boilers that show this code

What our technician checks

  • The system water level, topped up if needed
  • Bleeding of the hydraulic circuit
  • Water leaks
  • The pressure reading

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.