Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
De Dietrich Fault code De Dietrich
B07

Maximum flow-return difference exceeded

Blocking: it retries by itself

The temperature difference between the water leaving for the heating and the water returning to the boiler has gone above its maximum, because the water is not flowing enough or because of a sensor. On the Innovens MCA and Modulens G AGC it is a blocking message: the boiler stops and starts again by itself once the cause is gone.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Check that the radiator valves are open.
  3. Check the water pressure on the display: below 0.8 bar, top up with water as the user manual explains (recommended pressure 1.5 to 2.0 bar).
  4. Does the code stay on or come back? Do not take anything apart: call us.

Does your boiler show B07?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code B07

The meaning depends on the boiler: find yours below.

B07

BL.DT DEP RETOUR

Blocking: it retries by itself Innovens MCA, Modulens G AGC

The boilers that show this code

What our technician checks

  • Water circulation: direction, pump and valves
  • The system water pressure
  • The temperature sensors

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.