Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
De Dietrich Fault code De Dietrich
H.01.07

Exchanger to return temperature gap too large

Blocking: it retries by itself

The temperature difference between the heat exchanger and the water returning from the heating has gone above its maximum, because the water is not flowing enough or because of a sensor (C 230 Evo, AMC Pro Evo, Virtuens). It is a blocking fault: the boiler stops and starts again by itself once the cause is gone.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Check the system water pressure: below 0.8 bar, top up with water as the user manual explains.
  3. Check that the radiator valves are open.
  4. Does the code stay on or come back? Do not take anything apart: call us.

Does your boiler show H.01.07?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code H.01.07

The meaning depends on the boiler: find yours below.

H.01.07

Delta max T HEX-T ret

Blocking: it retries by itself AMC Pro Evo, C 230 Evo
H.01.07

Maximum difference between the heat exchanger temperature and the…

Blocking: it retries by itself Virtuens

What our technician checks

  • Water circulation: direction, pump and valves
  • The system water pressure
  • How clean the heat exchanger is
  • Bleeding the air from the system
  • Operation and fitting of the sensors

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.