Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
De Dietrich Fault code De Dietrich
E02.28

Lockout: flue gas pressure too high

Breakdown: the boiler is stopped

The pressure in the flue gas outlet has reached an extreme value too often: on the Modulens O AFC-S the message H02.26 appeared 5 times in 24 hours; on the CFU C the flue gas pressure switch opened 5 times in 24 hours. On the Modulens O AFC-S and the CFU C it is a lockout: the boiler stops and only starts again after our technician has removed the cause and reset it.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Do not reset the boiler: call us.
  3. Can you smell flue gases? Switch the boiler off, open the windows, leave the premises and call us.

Does your boiler show E02.28?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code E02.28

The meaning depends on the boiler: find yours below.

E02.28

The appliance is in Error state because of an extreme value of the flue gas pressure…

Breakdown: the boiler is stopped Modulens O AFC-S
E02.28

Flue gas P error

Breakdown: the boiler is stopped CFU C

What our technician checks

  • Fouling of the heat exchanger, cleaned
  • The burner settings
  • Leak-tightness and condition of the flue, cleaned if necessary
  • Modulens O AFC-S: the condensate drain and the trap, cleaned
  • Modulens O AFC-S: the pressure switch wiring, and the switch replaced if it has failed

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.