Maximum flow temperature exceeded
Breakdown: the boiler is stopped
The water leaving the boiler for the heating (the flow) has gone above its maximum temperature, because the water is not flowing, or not flowing enough, through the boiler or the system; on the MCR-S the code can also come from a short-circuited flow sensor. On the AMC 24/28 BIC, AMC Pro Evo, C 230 Evo, MCR-S, MPX2 Compact and Virtuens it is a lockout: the boiler stops and only starts again once the cause has been removed and the boiler has been reset.
What you can do
- Write down the code shown and the boiler model (on the rating plate).
- Reset the boiler once only.
- If the code comes back, do not keep trying and do not take anything apart: call us.
Does your boiler show E.04.03?
Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.
* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.
The variants of code E.04.03
The meaning depends on the boiler: find yours below.
T flow max.
Max flow temp
Maximum flow temperature exceeded or flow temperature sensor short-circuited
Maximum flow temperature exceeded
What our technician checks
- Water circulation through the boiler and the system: direction, pump and valves
- The system water pressure
- Venting the air (manual vent cycle)
- How clean the heat exchanger is
- How the sensors work