Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Bulex Fault code Bulex
S.76

Water pressure too low, top up

Information: nothing to do

The water pressure in the heating circuit is too low and the boiler shows a maintenance message: it is not yet in fault. Topping up the water is usually enough; if the pressure drops further, the boiler stops for safety (code F.22).

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Check the water pressure (display or gauge): below 0.8 bar, top up the heating water as your installer showed you.
  3. Does the code stay on or come back? Do not take anything apart: call us.

Nothing to do

This message belongs to the boiler's normal operation.

Call us

The variants of code S.76

The meaning depends on the boiler: find yours below.

S.76

System pressure too low

Information: nothing to do Thematek C25

What our technician checks

  • The system pressure, with a top-up

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.