Control electronics fault
Breakdown: the boiler is stopped
The boiler electronics (burner control unit, base controller or KIM coding plug) report a fault. Depending on the number shown next to the code, the boiler stops temporarily or locks out.
What you can do
- Write down the code shown, the number next to it if there is one, and the boiler model (on the rating plate).
- Reset the boiler once only.
- If the code comes back, do not keep trying and do not take anything apart: call us.
Does your boiler show EL?
Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.
* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.
Choose a real expert
Ecowatt is an approved Buderus System Partner: factory training in Germany, direct access to spare parts, one contact.
The variants of code EL
The small number shown beside the code tells which.
Internal fault
The burner control unit or the KIM is faulty
The burner control unit or the KIM is faulty
The burner control unit or the KIM is faulty
The boilers that show this code
What our technician checks
- The wiring and connectors of the burner control unit
- GB172i: the connectors, the wiring and the ignition cables, and the air-gas ratio
- The coding plug (KIM), replaced if necessary
- The burner control unit, the base controller (BC20, BC25) or the control unit, replaced if necessary