Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Buderus Fault code Buderus
9P

KIM not recognized or burner control unit faulty

Breakdown: the boiler is stopped

The electronics do not recognize the KIM, the boiler identification module, or the burner control unit is faulty. The boiler locks out and will only restart after a reset.

What you can do

  1. Write down the code shown, the number next to it if there is one, and the boiler model (on the rating plate).
  2. Reset the boiler once only.
  3. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show 9P?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

Buderus

Choose a real expert

Ecowatt is an approved Buderus System Partner: factory training in Germany, direct access to spare parts, one contact.

The variants of code 9P

The small number shown beside the code tells which.

9P
239

KIM not recognised

Breakdown: the boiler is stopped GB072, GB162, GB172

The boilers that show this code

What our technician checks

  • The KIM, correctly inserted, replaced if necessary (GB072, GB172)
  • The wiring and connectors of the burner control unit (GB162)
  • The burner control unit, replaced if necessary, then the boiler behavior checked (GB162)

The same fault on other boilers

Recent boilers show alone the number older ones show beside the code.

239

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.