Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Buderus Fault code Buderus
4F

Water too hot at the safety sensor

Breakdown: the boiler is stopped

The safety temperature sensor measures more than 105 °C. The boiler locks out and will only restart after a reset.

What you can do

  1. Write down the code shown, the number next to it if there is one, and the boiler model (on the rating plate).
  2. Check the water pressure: at least 1 bar, or the needle in the green zone of the pressure gauge. Too low? Top up with the boiler cold, the way your installer showed you.
  3. Check that enough radiators are open.
  4. Reset the boiler once only.
  5. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show 4F?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

Buderus

Choose a real expert

Ecowatt is an approved Buderus System Partner: factory training in Germany, direct access to spare parts, one contact.

The variants of code 4F

The small number shown beside the code tells which.

4F
219

The temperature sensor measures a temperature higher than 105 °C

Breakdown: the boiler is stopped GB162

The boilers that show this code

What our technician checks

  • The operating pressure and venting of the system and the boiler
  • The water flow rate in the system
  • The operation of the pump and the safety sensor, replaced if necessary

The same fault on other boilers

Recent boilers show alone the number older ones show beside the code.

219

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.