Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Buderus Fault code Buderus
4E

Temperature sensor test failed

Breakdown: the boiler is stopped

The temperature sensor test has failed (4E 278), or the return sensor reads a higher temperature than the flow sensor (4E 347, new start after 10 minutes). In the first case the boiler locks out, in the second it stops temporarily.

What you can do

  1. Write down the code shown, the number next to it if there is one, and the boiler model (on the rating plate).
  2. Reset the boiler once only.
  3. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show 4E?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

Buderus

Choose a real expert

Ecowatt is an approved Buderus System Partner: factory training in Germany, direct access to spare parts, one contact.

The variants of code 4E

The small number shown beside the code tells which.

4E
278

The sensor test failed

Breakdown: the boiler is stopped GB162
4E
347

The temperature measured by the return temperature sensor is higher than that measured…

Blocking: it retries by itself GB162

The boilers that show this code

What our technician checks

  • The wiring and connectors of each sensor
  • The flow and return sensor cables: not swapped
  • The operation of the sensors, measured with an ohmmeter; replaced if necessary

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.