Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Buderus Fault code Buderus
318

Flue gas temperature sensor open circuit

Breakdown: the boiler is stopped

The flue gas temperature sensor has an open circuit, or on the GB162 (1Y 318) is not working properly. For safety, the boiler locks out and only restarts after a reset.

What you can do

  1. Write down the code shown, the number next to it if there is one, and the boiler model (on the rating plate).
  2. Reset the boiler once only.
  3. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show 318?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

Buderus

Choose a real expert

Ecowatt is an approved Buderus System Partner: factory training in Germany, direct access to spare parts, one contact.

The variants of code 318

The small number shown beside the code tells which.

318

Flue gas temperature sensor open circuit

Breakdown: the boiler is stopped GB272

The boilers that show this code

What our technician checks

  • The connector and cable of the flue gas temperature sensor
  • The sensor, measured with an ohmmeter and compared with the manufacturer's table; replaced if necessary
  • The control unit or the burner control unit, replaced if necessary

The same fault on other boilers

Recent boilers show alone the number older ones show beside the code.

1Y

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.