Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Buderus Fault code Buderus
2C

Water too hot during hot water production

Blocking: it retries by itself

During domestic hot water production, the flow temperature is above 85 °C. This code appears in the manual for GB162 boilers older than version V3.

What you can do

  1. Write down the code shown, the number next to it if there is one, and the boiler model (on the rating plate).
  2. Check the water pressure: at least 1 bar, or the needle in the green zone of the pressure gauge. Too low? Top up with the boiler cold, the way your installer showed you.
  3. Does the code stay on or come back? Do not take anything apart: call us.

Does your boiler show 2C?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

Buderus

Choose a real expert

Ecowatt is an approved Buderus System Partner: factory training in Germany, direct access to spare parts, one contact.

The variants of code 2C

The small number shown beside the code tells which.

2C
348

In domestic hot water mode: the flow temperature is higher than 85 °C

Blocking: it retries by itself GB162

The boilers that show this code

What our technician checks

  • The operating pressure and venting of the system and the boiler
  • The wiring and operation of the pump and the flow temperature sensor, replaced if necessary

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.