Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Buderus Fault code Buderus
2982

No water flow or flow too low

Breakdown: the boiler is stopped

The boiler detects no water flow, or a flow that is too low. For safety, the boiler locks out and only restarts after a reset.

What you can do

  1. Write down the code shown, the number next to it if there is one, and the boiler model (on the rating plate).
  2. Reset the boiler once only.
  3. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show 2982?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

Buderus

Choose a real expert

Ecowatt is an approved Buderus System Partner: factory training in Germany, direct access to spare parts, one contact.

The variants of code 2982

The small number shown beside the code tells which.

2982

No flow or too low a flow detected

Breakdown: the boiler is stopped GB272

The boilers that show this code

What our technician checks

  • The proper operation of the heating circuit
  • The pump settings, adapted to the system
  • The connectors on the sensor and on the control unit, and the sensor fastening
  • The sensor and its connection cable, replaced if necessary

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.