Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Buderus Fault code Buderus
2964

Water flow too low in the boiler

Blocking: it retries by itself

The water flow through the heat exchanger is too low. This is not a lockout: the boiler starts again by itself as soon as the cause is gone.

What you can do

  1. Write down the code shown, the number next to it if there is one, and the boiler model (on the rating plate).
  2. Check that enough radiators are open.
  3. Does the code stay on or come back? Do not take anything apart: call us.

Does your boiler show 2964?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

Buderus

Choose a real expert

Ecowatt is an approved Buderus System Partner: factory training in Germany, direct access to spare parts, one contact.

The variants of code 2964

The small number shown beside the code tells which.

2964

Flow rate too low in the heat exchanger

Blocking: it retries by itself GB272

The boilers that show this code

What our technician checks

  • The proper operation of the heating circuit
  • The pump settings, adapted to the system
  • The connectors on the temperature sensor and the control unit
  • The fastening of the temperature sensor
  • The sensor and its connection cable, replaced if necessary

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.