Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Buderus Fault code Buderus
2963

Temperature sensor signal out of range

Blocking: it retries by itself

The flow and heat exchanger temperature sensors are sending a signal outside the permitted range. The boiler stops temporarily and restarts by itself once the fault is cleared.

What you can do

  1. Write down the code shown, the number next to it if there is one, and the boiler model (on the rating plate).
  2. Does the code stay on or come back? Do not take anything apart: call us.

Does your boiler show 2963?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

Buderus

Choose a real expert

Ecowatt is an approved Buderus System Partner: factory training in Germany, direct access to spare parts, one contact.

The variants of code 2963

The small number shown beside the code tells which.

2963

Flow temperature sensor and heat exchanger temperature sensor signal outside the…

Blocking: it retries by itself GB172i.2, GB182i.2, GB192i.2, GB272

The boilers that show this code

What our technician checks

  • The connectors on the sensor and the control unit
  • The sensor mounting
  • The sensor, measured with an ohmmeter and compared with the manufacturer's table, and its cable; replaced if necessary

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.