Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Buderus Fault code Buderus
2952

Internal fault during flame signal test

Breakdown: the boiler is stopped

The electronics found an internal fault while testing the ionization signal, which is used to monitor the flame. The boiler locks out and only restarts after a reset.

What you can do

  1. Write down the code shown, the number next to it if there is one, and the boiler model (on the rating plate).
  2. Reset the boiler once only.
  3. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show 2952?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

Buderus

Choose a real expert

Ecowatt is an approved Buderus System Partner: factory training in Germany, direct access to spare parts, one contact.

The variants of code 2952

The small number shown beside the code tells which.

2952

Internal fault during the ionisation signal test

Breakdown: the boiler is stopped GB172i.2, GB182i.2, GB192i.2, GB272

The boilers that show this code

What our technician checks

  • A reset, then the boiler's behavior
  • The control unit and the burner control unit, replaced if necessary

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.