Flame lost too often
Breakdown: the boiler is stopped
The burner flame has gone out too many times. For safety, the boiler locks out and only restarts after a reset.
What you can do
- Write down the code shown, the number next to it if there is one, and the boiler model (on the rating plate).
- Check that the boiler's gas shutoff valve is open.
- Reset the boiler once only.
- If the code comes back, do not keep trying and do not take anything apart: call us.
Does your boiler show 2951?
Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.
* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.
Choose a real expert
Ecowatt is an approved Buderus System Partner: factory training in Germany, direct access to spare parts, one contact.
The variants of code 2951
The small number shown beside the code tells which.
Too many flame losses
The boilers that show this code
What our technician checks
- The gas shutoff valves (main and appliance) and the gas line
- Ionization operation and the ground connection (PE) in the control unit
- The ignition and monitoring electrodes, their cables and their connector, replaced if necessary
- The burner setting, also at minimum load, or its nozzles
- The gas valve, replaced if necessary
- The flue gas exhaust and the combustion air supply (ventilation opening)
- The heat exchanger on the flue gas side, cleaned
- The control unit or the burner control unit, replaced if necessary