Safety temperature limiter tripped
Breakdown: the boiler is stopped
On recent boilers: a temperature that is too high was measured in the heat exchanger or in the flue gas, and the safety limiter shut the boiler down.
What you can do
- Write down the code shown, the number next to it if there is one, and the boiler model (on the rating plate).
- Check the water pressure: at least 1 bar, or the needle in the green zone of the pressure gauge. Too low? Top up with the boiler cold, the way your installer showed you.
- Check that enough radiators are open.
- Reset the boiler once only.
- If the code comes back, do not keep trying and do not take anything apart: call us.
Does your boiler show 224?
Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.
* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.
Choose a real expert
Ecowatt is an approved Buderus System Partner: factory training in Germany, direct access to spare parts, one contact.
The variants of code 224
The small number shown beside the code tells which.
The safety temperature limiter has tripped
The boilers that show this code
What our technician checks
- The heat exchanger limiter, its connector and its cable
- The flue gas temperature limiter and its cable (GB192i)
- Heating water circulation: valves open, pump, venting
- The system water pressure
- Circulation in the hot water cylinder circuit
- The water side of the heat exchanger