Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Buderus Fault code Buderus
212

Temperature rising too fast

Information: nothing to do

The flow or safety temperature sensors measure a temperature rise that is too fast. The GB192i lists this code among operating messages, not among faults.

What you can do

  1. Write down the code shown, the number next to it if there is one, and the boiler model (on the rating plate).
  2. Check that enough radiators are open.
  3. Bleed the radiators, then check the water pressure again.
  4. Does the code stay on or come back? Do not take anything apart: call us.

Nothing to do

This message belongs to the boiler's normal operation.

Call us
Buderus

Choose a real expert

Ecowatt is an approved Buderus System Partner: factory training in Germany, direct access to spare parts, one contact.

The variants of code 212

The small number shown beside the code tells which.

212

The flow or safety temperature sensors measure a temperature rise that is too fast

Information: nothing to do GB192i

The boilers that show this code

What our technician checks

  • The operating pressure and venting of the appliance and the system
  • The water flow rate in the system
  • The wiring and operation of the pump and the sensor involved, replaced if needed

The same fault on other boilers

Recent boilers show alone the number older ones show beside the code.

2P

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.