Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Buderus Fault code Buderus
1A

Flue gas temperature too high

Breakdown: the boiler is stopped

The flue gas temperature sensor measures a temperature that is too high. The boiler shuts down for safety; if the fault persists, it locks out and must be reset.

What you can do

  1. Write down the code shown, the number next to it if there is one, and the boiler model (on the rating plate).
  2. Reset the boiler once only.
  3. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show 1A?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

Buderus

Choose a real expert

Ecowatt is an approved Buderus System Partner: factory training in Germany, direct access to spare parts, one contact.

The variants of code 1A

The small number shown beside the code tells which.

1A
316

The temperature measured by the flue gas temperature sensor is too high

Breakdown: the boiler is stopped GB162

The boilers that show this code

What our technician checks

  • The water pressure, and venting of the system and the boiler
  • The water flow rate in the system
  • The wiring and operation of the pump and the flue gas temperature sensor
  • Fouling of the boiler, serviced if needed

The same fault on other boilers

Recent boilers show alone the number older ones show beside the code.

316

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.