Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Bosch Fault code Bosch
A7

Hot water temperature sensor faulty

Breakdown: the boiler is stopped

The boiler's hot water temperature sensor (NTC, on boilers that also make hot water) is faulty: the sensor or its cable is broken or short-circuited. It is a fault: the boiler stops and only starts again after a reset.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Reset the boiler once only.
  3. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show A7?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code A7

The meaning depends on the boiler: find yours below.

A7

DHW NTC faulty (ZWB only)

Breakdown: the boiler is stopped Condens 3000 W

The boilers that show this code

What our technician checks

  • The hot water NTC sensor and its cable (break, short circuit), replaced if needed
  • The coding plug, firmly seated, replaced if needed

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.