Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Bosch Fault code Bosch
227

The boiler detects no flame

Breakdown: the boiler is stopped

The boiler tries to light its burner but detects no flame: the gas (closed tap, pressure), the ignition, the electrodes or the flue may be the cause. The boiler makes further ignition attempts by itself; after the fifth, the fault becomes a locking fault and the boiler only restarts after a reset.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Check that the boiler's gas tap is open.
  3. Reset the boiler once only.
  4. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show 227?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code 227

The meaning depends on the boiler: find yours below.

227

Flame not detected

Breakdown: the boiler is stopped GC2300iW

The boilers that show this code

What our technician checks

  • The gas tap, open
  • The gas supply pressure
  • The ionisation signal and the mains connection
  • The electrodes and their cables, replaced if needed
  • The flue system, cleaned or repaired
  • The air-gas ratio and the burner setting
  • Cleaning the heat exchanger
  • The gas valve, replaced if needed

The same fault on other boilers

Recent boilers show alone the number older ones show beside the code.

EA

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.