Too little heat taken off during calibration
Breakdown: the boiler is stopped
During the automatic calibration of its combustion, the boiler could not pass enough heat to the system and the temperature monitor tripped. The burner locks out and the boiler only starts again after a reset.
What you can do
- Write down the code shown and the boiler model (on the rating plate).
- Reset the boiler once only.
- If the code comes back, do not keep trying and do not take anything apart: call us.
Does your boiler show 373?
Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.
* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.
The variants of code 373
The meaning depends on the boiler: find yours below.
Heat dissipation too low during calibration
What our technician checks
- Heat being taken off by the system
- The circulating pump: fault, scale or blockage
- The 3-way diverter valve and venting the system
- The flow rate sensor