Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Viessmann Fault code Viessmann
355

Flame signal present before ignition

Breakdown: the boiler is stopped

When the burner starts, the boiler already sees a flame signal: the cause may be a condensate build-up, the electronics or the ignition transformer. For safety, the burner locks out and the boiler only starts again after a reset.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Reset the boiler once only.
  3. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show 355?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code 355

The meaning depends on the boiler: find yours below.

355

Condensate accumulation or reference check of the analogue signal: flame signal already…

Breakdown: the boiler is stopped Vitodens 100-W B1HF

What our technician checks

  • If condensate has built up: the insulating ring, the insulation block, the electrodes and the burner grid, to be replaced
  • The HBMU central electronic module, to be replaced
  • The ignition transformer and ignition cable, replaced if needed
  • Removing the fan unit before opening the burner, with the electronics protected from water

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.