Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Remeha Fault code Remeha
Su:5

Temperature gap to the return too large

Blocking: it retries by itself

The temperature difference between the heated water and the water coming back from the heating (return) is too large: on the Gas 210 Eco Pro it is measured between the heat exchanger and the return, on the Gas 310/610 Eco Pro between the flow and the return. Most often too little water is flowing, sometimes a sensor is at fault: it is a blocking code, the boiler stops and starts again by itself once the cause is gone.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Check the system water pressure: at least 0.8 bar. Too low? Top up with water as your installer showed you.
  3. Does the code stay on or come back? Do not take anything apart: call us.

Does your boiler show Su:5?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code Su:5

The meaning depends on the boiler: find yours below.

Su:5

Temperature difference too large between the heat exchanger and the return temperature

Blocking: it retries by itself Gas 210 Eco Pro
Su:5

Maximum difference between flow and return temperature exceeded

Blocking: it retries by itself Gas 310/610 Eco Pro

What our technician checks

  • Water circulation: direction, pump and valves
  • Bleeding air from the system (Gas 210 Eco Pro)
  • The system water pressure
  • Fouling of the heat exchanger
  • The temperature sensors: deviations, operation and fitting

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.