Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Remeha Fault code Remeha
Su:4

Heat exchanger temperature rising too fast

Blocking: it retries by itself

The water temperature in the heat exchanger (on the Gas 310/610 Eco Pro, the flow temperature) rises faster than allowed, because too little water is flowing through it; on the Gas 210 Eco Pro a sensor can also be at fault. On the Gas 210 Eco Pro and Gas 310/610 Eco Pro it is a blocking code: the boiler stops and starts again by itself once the cause is gone.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Check the system water pressure: at least 0.8 bar. Too low? Top up with water as your installer showed you.
  3. Does the code stay on or come back? Do not take anything apart: call us.

Does your boiler show Su:4?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code Su:4

The meaning depends on the boiler: find yours below.

Su:4

Maximum rise of the heat exchanger temperature exceeded

Blocking: it retries by itself Gas 210 Eco Pro
Su:4

The maximum permitted rate of rise of the flow temperature in the heat exchanger has

Blocking: it retries by itself Gas 310/610 Eco Pro

What our technician checks

  • Water circulation: direction, pump and valves
  • The reason for the heat demand (Gas 310/610 Eco Pro)
  • Bleeding air from the system (Gas 210 Eco Pro)
  • The system water pressure (Gas 210 Eco Pro)
  • Fouling of the heat exchanger (Gas 210 Eco Pro)
  • Deviations of the temperature sensors (Gas 210 Eco Pro)

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.