Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Remeha Fault code Remeha
Su:3

Heat exchanger temperature limit exceeded

Blocking: it retries by itself

On the Gas 210 Eco Pro, the heat exchanger has gone above its maximum temperature; on the Gas 310/610 Eco Pro, its temperature has risen faster than allowed. In both cases too little water is flowing through the boiler (on the Gas 310/610 Eco Pro a sensor can also be at fault): it is a blocking code, the boiler stops and starts again by itself once the cause is gone.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Check the system water pressure: at least 0.8 bar. Too low? Top up with water as your installer showed you.
  3. Does the code stay on or come back? Do not take anything apart: call us.

Does your boiler show Su:3?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code Su:3

The meaning depends on the boiler: find yours below.

Su:3

Maximum heat exchanger temperature exceeded

Blocking: it retries by itself Gas 210 Eco Pro
Su:3

The maximum rise of the heat exchanger temperature has been exceeded

Blocking: it retries by itself Gas 310/610 Eco Pro

What our technician checks

  • Water circulation: direction, pump and valves
  • Bleeding air from the system (Gas 210 Eco Pro)
  • The system water pressure
  • Fouling of the heat exchanger
  • The temperature sensors: deviations, operation and fitting

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.