Maximum flow temperature exceeded
Breakdown: the boiler is stopped
The boiler's flow water has exceeded its maximum safety temperature, because the water does not circulate or too little (pressure, air, pump, valves) or because of a sensor; on the Avanta Ace the same code also reports a short-circuited flow sensor. On the Calenta Ace, Tzerra Ace, Quinta Ace, Quinta 45-115, Gas 210 Ace, Gas 220 Ace, Gas 320/620 Ace, Calenta Ace-Matic, Tzerra Ace-Matic and Avanta Ace it is a lockout: the boiler stops and only starts again once the cause has been removed and the boiler has been reset.
What you can do
- Write down the code shown and the boiler model (on the rating plate).
- Check the system's water pressure: below 0.8 bar, top up with water as the user manual explains.
- Reset the boiler once only.
- If the code comes back, do not keep trying and do not take anything apart: call us.
Does your boiler show E04.03?
Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.
* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.
The variants of code E04.03
The meaning depends on the boiler: find yours below.
Maximum flow temperature exceeded or flow temperature sensor short-circuited
Max flow T
Maximum flow temperature exceeded
Flow temp limit
Flow temperature is above the maximum
Max flow T
What our technician checks
- Circulation: direction, pump and valves
- The system's water pressure
- Bleeding the air out of the system
- Whether the heat exchanger is clean
- The sensors' operation and fitting