Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
De Dietrich Fault code De Dietrich
L36

Flame lost several times

Breakdown: the boiler is stopped

The burner flame went out several times while running: more than 5 times in 24 hours on the Innovens MCA and Modulens G AGC (gas), where the boiler no longer measures the ionisation current that confirms the flame, and 3 times during one heat demand on the Modulens O AFC (oil). It is a lockout fault: the control panel shows the code and the boiler stays off until it is reset.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Innovens MCA or Modulens G AGC: check that the boiler's gas tap is fully open.
  3. Reset the boiler once only.
  4. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show L36?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code L36

The meaning depends on the boiler: find yours below.

L36

DEF.IONISATION

Breakdown: the boiler is stopped Innovens MCA, Modulens G AGC
L36

DEF.DISP.FLAM.

Breakdown: the boiler is stopped Modulens O AFC

The boilers that show this code

What our technician checks

  • Innovens MCA, Modulens G AGC: the ionisation current (flame signal)
  • Innovens MCA, Modulens G AGC: whether the gas tap is open
  • Modulens O AFC: the cause of the flame losses during the heat demand

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.