Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
De Dietrich Fault code De Dietrich
H.02.84

Two functions set on the same connector

Blocking: it retries by itself

The current settings of the Virtuens enable two functions that use the same connector pins of an actuator or sensor: a settings conflict on the SCB-10 extension board. It is a temporary stop, not a lockout: the boiler starts again by itself once the cause has been removed.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Does the code stay on or come back? Do not take anything apart: call us.

Does your boiler show H.02.84?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code H.02.84

The meaning depends on the boiler: find yours below.

H.02.84

The current parameter configuration causes a conflict of hardware resources

Blocking: it retries by itself Virtuens

What our technician checks

  • Connector pins shared between enabled functions
  • The functions enabled in the parameters, limited to the wanted ones
  • Disabling functions one by one to find the conflicting ones

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.