Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
De Dietrich Fault code De Dietrich
B22

Flame loss or burner settings

Blocking: it retries by itself

On the Innovens MCA and Modulens G AGC the burner flame went out during operation (no ionisation current); on the Modulens O AFC the same code reports wrong burner settings. It is a blocking message: the boiler stops and starts again by itself once the cause is gone.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. On an Innovens MCA or Modulens G AGC, check that the boiler's gas tap is open.
  3. Does the code stay on or come back? Do not take anything apart: call us.

Does your boiler show B22?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code B22

The meaning depends on the boiler: find yours below.

B22

BL.DISP.FLAMME

Blocking: it retries by itself Innovens MCA, Modulens G AGC
B22

BL.PARAM.BRULEUR

Blocking: it retries by itself Modulens O AFC

The boilers that show this code

What our technician checks

  • The ionisation current and the gas tap (Innovens MCA, Modulens G AGC)
  • The burner settings (Modulens O AFC)

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.