Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
De Dietrich Fault code De Dietrich
B19

Boiler not configured

Blocking: it retries by itself

The boiler is not configured: its circuit board has been changed (PSU board on the Innovens MCA and Modulens G AGC, PCU board on the Modulens O AFC). It is a blocking message: the boiler stops and starts again by itself once our technician has done the configuration.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Does the code stay on or come back? Do not take anything apart: call us.

Does your boiler show B19?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code B19

The meaning depends on the boiler: find yours below.

B19

BL.PAS DE CONFIG

Blocking: it retries by itself Innovens MCA, Modulens G AGC, Modulens O AFC

The boilers that show this code

What our technician checks

  • The boiler configuration after the PSU board was changed (PCU board on the Modulens O AFC)

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.