Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
De Dietrich Fault code De Dietrich
B15

Gas pressure too low or internal fault

Blocking: it retries by itself

On the Innovens MCA and Modulens G AGC (gas) the boiler detects a gas pressure that is too low (gas tap, setting of the gas pressure switch); on the Modulens O AFC (oil) the same BL.PRESS.GAZ message reports an internal fault. It is a blocking message: the boiler stops and starts again by itself once the cause is gone.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. On an Innovens MCA or Modulens G AGC, check that the boiler's gas tap is open.
  3. Does the code stay on or come back? Do not take anything apart: call us.

Does your boiler show B15?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code B15

The meaning depends on the boiler: find yours below.

B15

BL.PRESS.GAZ

Blocking: it retries by itself Innovens MCA, Modulens G AGC, Modulens O AFC

The boilers that show this code

What our technician checks

  • The gas tap and the gas pressure (Innovens MCA, Modulens G AGC)
  • The setting of the gas pressure switch on the SCU board (Innovens MCA, Modulens G AGC)
  • Modulens O AFC: the internal fault reported by the control

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.