Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Buderus Fault code Buderus
210

Flue gas temperature too high

Information: nothing to do

The flue gas temperature sensor measured a temperature that was too high and opened. On the GB192i, the boiler reports this as an operating message; on the GB162 (1C 210), it is a locking fault that requires a reset.

What you can do

  1. Write down the code shown, the number next to it if there is one, and the boiler model (on the rating plate).
  2. Reset the boiler once only.
  3. If the code comes back, do not keep trying and do not take anything apart: call us.

Nothing to do

This message belongs to the boiler's normal operation.

Call us
Buderus

Choose a real expert

Ecowatt is an approved Buderus System Partner: factory training in Germany, direct access to spare parts, one contact.

The variants of code 210

The small number shown beside the code tells which.

210

The temperature measured by the flue gas temperature sensor is too high; as a result it…

Information: nothing to do GB192i

The boilers that show this code

What our technician checks

  • The operation of the flue gas temperature sensor, replaced if needed
  • Fouling of the appliance, serviced if needed

The same fault on other boilers

Recent boilers show alone the number older ones show beside the code.

1C

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.