Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Bosch Fault code Bosch
363

Fault during the ionisation signal test

Breakdown: the boiler is stopped

While testing the ionisation signal, which it uses to monitor the flame, the boiler's electronics detected a fault. The boiler locks out for safety: it only restarts after a reset, and if the code comes back, our technician needs to check the electronics.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Reset the boiler once only.
  3. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show 363?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code 363

The meaning depends on the boiler: find yours below.

363

System fault in the appliance electronics: fault during the ionisation signal test

Breakdown: the boiler is stopped GC2300iW

The boilers that show this code

What our technician checks

  • The boiler electronics: a reset, then replacement if needed

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.